Don´t get signal on the screen
Posted:
Thu 24. Feb 2022, 18:43by nmarconi
Hi, i am new, i am working with ADS1299 and using brainBay...the problem is that , everything looks allright, there is SPI comunication , and UART eork OK, but i can't see any signal in the screen of BrianBay...what could be the problem..
Posted: Thu 24. Feb 2022, 18:43
by Advertising
Re: Don´t get signal on the screen
Posted:
Sat 13. Aug 2022, 11:10by chris
hi nmarconi,
Brainbay supports a number of biosignal acquisition devices and protocols
(see menu -> insertElement -> Source -> Biosignal/EEGAmplifier)
It is not sufficient to attach a chip like the ADS1299 and transfer raw values via UART - the data stream must be implemented according to a supported protocol
for example the OpenEEG P2 packet format which is documented here:
http://openeeg.sourceforge.net/doc/mode ... odeeg-p2.chttps://www.vilistus.com/h2jha23h41k/Op ... iption.pdf